Howto/Setup Bridged OpenVPN server on Ubuntu 10.04

From Interpause
Revision as of 13:35, 23 December 2011 by Andrew (talk | contribs) (Created page with '== The desired setup requirements == I want users to be able to access my network remotely as if they were locally. Also, I want client side configuration steps kept to a minimum…')
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search

The desired setup requirements

I want users to be able to access my network remotely as if they were locally. Also, I want client side configuration steps kept to a minimum. Specifically, I want clients to use the "alternative OpenVPN authentication method". Also, I want clients to be able to see all machines on the server's side (this last bit was what cost me a LOT of time to figure out). Last but not least, I do NOT want all traffic being forwarded through the VPN.

My setup

  • The following was tested on OpenVPN 2.1 but may work for other version
  • I have a standard router that acts as my gateway, located at 192.168.8.1
  • My OpenVPN server is located at 192.168.8.141
  • My router is setup to assign ip addresses upon requests via dhcp but my servers have static ips.


The Steps

Step 1: Install a virtual bridged adapter 

https://help.ubuntu.com/10.04/serverguide/C/network-configuration.html#bridging

Step 2: Install

Retrieved from "https://interpause.com/index.php?title=Howto/Setup_Bridged_OpenVPN_server_on_Ubuntu_10.04&oldid=163"