Howto/Setup Bridged OpenVPN server on Ubuntu 10.04: Difference between revisions
From Interpause
Jump to navigationJump to search
(Created page with '== The desired setup requirements == I want users to be able to access my network remotely as if they were locally. Also, I want client side configuration steps kept to a minimum…') |
No edit summary |
||
| Line 3: | Line 3: | ||
== My setup == | == My setup == | ||
* The following was tested on OpenVPN 2.1 but may work for other version | * The following was tested on '''OpenVPN 2.1''' but may work for other version | ||
* I have a standard router that acts as my gateway, located at 192.168.8.1 | * I have a standard router that acts as my gateway, located at '''192.168.8.1''' | ||
* My OpenVPN server is | * My OpenVPN server has '''one NIC on eth1''' and its ip address is '''192.168.8.141''' | ||
* My router is setup to assign ip addresses upon requests via dhcp but my servers have static ips. | * My router is setup to assign ip addresses upon requests via '''dhcp''' but my servers have '''static ips'''. | ||
== The Steps == | == The Steps == | ||
Revision as of 14:37, 23 December 2011
The desired setup requirements
I want users to be able to access my network remotely as if they were locally. Also, I want client side configuration steps kept to a minimum. Specifically, I want clients to use the "alternative OpenVPN authentication method". Also, I want clients to be able to see all machines on the server's side (this last bit was what cost me a LOT of time to figure out). Last but not least, I do NOT want all traffic being forwarded through the VPN.
My setup
- The following was tested on OpenVPN 2.1 but may work for other version
- I have a standard router that acts as my gateway, located at 192.168.8.1
- My OpenVPN server has one NIC on eth1 and its ip address is 192.168.8.141
- My router is setup to assign ip addresses upon requests via dhcp but my servers have static ips.
The Steps
Step 1: Install a virtual bridged adapter
https://help.ubuntu.com/10.04/serverguide/C/network-configuration.html#bridging
Step 2: Install
